The Stay editor can be accessed via:
Selecting the stay within the work space; or
From the Overview Limit State Table tab by clicking on the Stay name in column 3
The Stay editor is only shown if exactly one stay is ticked. It is there purely as a convenience to allow some stay properties to be edited within the tip load section when assessing tip load capacity of poles.
Stays can also be edited directly by clicking on them in the workspace.
The following sections provide further detail on the numbered items in the screenshot above.
4. Stay Cable Type + Stay Type
Stay cable type and style type can be changed here. The Stay Types are:
Side Walk Stay
Ground Stay
5. Distance from Top
The stay's attachment distance from the pole top.
6. Offset Distance
The distance between pole at ground and stay at ground.
7. Bearing angle
The angle of the stay at ground to north, relative to the pole:
8. Attach Height
The stay's attachment distance from ground.
9. Ground Angle
The Angle between the stay and ground.